Table of Contents
Advertisement
(19) Check another resolution and press the button, "Change All device resolution"
Note: In cases of (17),(18) and (19), the devices are rebooted if those fuction is applied.
5) Receiver(D) setting
♦ You have to register a group of transmitters up to max. 16 to each receiver.
Note: Before add the Tx IP to the list , firstly insert the name to each transmitter.
♦ You can insert device name to each transmitter by double clicking an area of the device
name (top right). (Eg. No 1 or Hitach16.)
(1) Double click an area of device name
(2) Insert a name to the area of the device name (top right)
(3) Select a receiver (including IP address) from the list of Rxs
(4) Click "Tx List Reload" and add a transmitter from transmitter (E) list.
(5) Or, remove a transmitter from selected transmitters.
(6) Repeat (3)-(4) to add another transmitter.
♦ You can change the order of the transmitters in the group of receiver on the multi-screen.
(7) Double click an area of the index
(8) Change the number and then the number and matched number change all together.
Eg. it changes to Index0 (no. 2) and index1 (no.1) on the above figure.
- 24 -
Advertisement
Table of Contents
