opticis IPKVM-310-ED User Manual page 16

♦ You can automatically detect the devices.
This method is to find devices automatically and register easily if the devices, Txs and Rxs, are
already connected in the network.
(1) Firstly, check and enter IP class to find easily. eg. 192.168.0.xxx
(2) Press "Start" button.
♦ You automatically detected devices so, you can see 4 IP Addresses connected to the
network on the above figure.
♦ You can rmanually add IP address of a transmitter or a receiver.
Note: Also you can add or change an IP address of each device in the condition of being
directly connected to PC through LAN cable using this same PC program.
(3) Select Device type on the top left corner. : Select one of Transmitter(E) and Receiver(D)
(4) Enter IP address in case of Txs. eg. 192.168.0.41
(5) Or enter IP address and select RTSP port from list(10000~25000) in case of Rxs
eg. 192.168.0.51, and 12000
(6) Press "Add" button to apply the device to the list.
- 16 -