Yardworks 060-2288-0 Owner's Manual page 12

Assembly and Adjustments - continued
To refill the spool (Fig. 5):
If you are unable to purchase a new pre-wound spool, you may purchase 0.065"
(1.65 mm) nylon monofilament cutting line and refill the spool that was supplied with
your grass trimmer.
1. Remove the spool from the trimmer head.
2. Cut a length of cutting line to approximately 20' (6.1 m) long and fold it in
half.
3. Loop the "V" end of the cutting line into the small notch on the inner rail of
the spool to anchor the line.
4. Wind the line evenly and tightly in a counter-clockwise direction. Make sure
each section of the spool contains a separate thread.
5. Do not wind the line beyond the edge of the cutting spool.
Fig. 5
12