How To Assembly The Blades & Light Kit - Fanimation FP8050 The Quattro Owner's Manual

How to Assemble the Blades and Light Kit
1. Slide blade through slot and secure using
3/16-24x12.5 mm washer head screws and
fiber washers (Figure 1).
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
2. Remove one of the three screws from the
Housing Support Bracket. Loosen the remaining
two screws without fully removing. Connect the
2-pin connector from the Upper Light Kit Plate to
the 2-pin connector from motor assembly
(Figure 2).
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
3. Assemble the Upper Light Kit Plate to the
Housing Support Bracket by aligning key slots
in Plate with the two screws in Support Bracket.
Assemble screw removed in step 2 and tighten
all three screws (Figure 3).
HARDWARE USED:
3/16-24 x 12.5mm
WASHER HEAD
SCREWS
FIBER WASHER
MOTOR ASSEMBLY
2-PIN CONNECTOR
LIGHT SOCKET 2-PIN
CONNECTOR
SCREWS (3)
9
BLADE
3/16-24 x 12.5mm WASHER
HEAD SCREW AND FIBER
WASHER (3 each per blade)
Figure 1
x 16
x 16
SCREWS (3)
MOTOR
ASSEMBLY
SUPPORT
BRACKET
UPPER LIGHT
Figure 2
KIT PLATE
MOTOR
ASSEMBLY
UPPER LIGHT
KIT PLATE
Figure 3