How To Wire Your Ceiling Fan - Fanimation FP8050 The Quattro Owner's Manual

Ceiling fan

Hide thumbs

Table Of Contents

Table of Contents

WARNING

To avoid possible electrical shock, be sure electricity

is turned off at the main fuse box before hanging

(Figure 1).

NOTE: If you are not sure if the outlet box is

grounded, contact a licensed electrician for advice, as

it must be grounded for safe operation.

NOTE: The hand-held remote included with this fan

has 16 different code combinations. To prevent

possible interference from or to other remote units,

simply change the combination code in your

transmitter and receiver.

1. To set the transmitter code, remove battery cover

by pressing firmly below arrow and sliding cover

off. Slide code switches to your choice of up or

down position. Factory setting is all up. Do not use

this position. With a small screwdriver or ball point

pen slide firmly up or down. Replace battery cover

on the transmitter (Figure 2).

2. To set the receiver unit code, slide code switches

to the same positions as set on your transmitter

(Figure 3).

3. Slide the receiver unit into the open end of the

hanger bracket (Figure 4).

4. Connect green wires from hanger bracket and

hanger ball to bare (ground) wire using wire

connector supplied. Connect black wire from

receiver unit marked "AC IN L" to black supply wire

using wire connector supplied. Connect white wire

from receiver unit marked "AC IN N" to white supply

wire using wire connector supplied. Connect white

wire from receiver unit marked "TO MOTOR N" to

white wire from fan using wire connector supplied

with receiver. Connect black wire from receiver unit

marked "TO MOTOR L" to black wire from fan

using wire connector supplied. Lastly, connect blue

wire from receiver to the blue fan light wire using

wire connector supplied. Position all connected

wires and receiver antenna to allow installation of

ceiling canopy (Figure 5).