Footplate - Sunrise Medical Xenon SA Directions For Use Manual

footplate

Various footboards are available on the Xenon SA. These
can be flipped up to make it easier to transfer to/from the
chair. They are described individually.
footrest and swing away latch
When fitting the footrests these are fitted in the swung-
away position (Fig. 6.7). Then simply turn them inwards
until the interlock engages (1). To remove the footrests,
use the lever (2) and swing the footrest outwards and lift
off. Check that the footrest is correctly engaged.
attentIon!
the footrests are not designed to be used to lift or
carry the wheelchairs with an occupant.
hanger play adjustment
In case of play the hanger (Fig. 6.8) can be adjusted in
the field. The hanger pin (1) is tapered and the play can
be reduced when the pin is unscrewed slightly.
Take the hanger off the chair in using the release mecha-
nism.
Use an screw driver and turn the pin (1) in the front care-
fully to the left. Then test the hanger on the chair. If the
hanger mechanism is not working/catching anymore,
please undo the task slightly.
If the play is still too large and the performance not ac-
cepted, please repeat the task.
lower leg lengths
By undoing the clamp screw (Fig. 6.9), you can adjust the
lower leg length. Loosen the clamp screw, adjust the tube
with the footboard to the desired position.
Tighten clamp screws again (see the page on torque).
Ensure that the plastic push joint is located under the
clamp screw in the correct position.
warnIngs!
• Do not stand on the footboard!
• When transferring, do not stand on the footboard,
there is a risk of tipping over and injury.
platform footplates
The footboard can be flipped up to make it easier to
transfer to and from the chair.
The footboard can also be tilted to six different angles
relative to a level surface.
Tighten screw (1) firmly on the outer side.
By removing the clips (2) the footplate can be adjusted to
three different positions toward both the front and rear.
Loosen the adjustment screw (3) to change the horizontal
position of the footplate.
For this purpose, the footplate must be flipped up.
(Fig. 6.10, 6.11 and 6.12).
When finished, make sure that all screws have been
properly tightened (see the page on torque).
A minimum interval of 2.5 centimetres from the ground
should always be maintained.
Fig. 6.7
Fig. 6.8
Fig. 6.9
Fig. 6.10
Fig. 6.11
Fig. 6.12
12
2
1
1