Lap Strap (Continued) - Sunrise Medical Xenon SA Directions For Use Manual

lap strap (continued)

When fastened check space between the lap belt and
user. When correctly adjusted it should not be possible to
insert more than the flat of the hand between the pelvic
restraint belt and the user, (Fig. 6.57).
The lap belt should be fxed so that the belt sits at an
angle of 45 degrees across the users pelvis. The user
should be upright and be as far back as possible in the
seat when correctly adjusted. The pelvic restraint belt
should not allow the user to slip down in the seat,.(Fig.
6.58).
to fasten buckle:
Firmly push male buckle into female buckle, (Fig. 6.59).
to release buckle:
Press the RED button in the centre of the buckle then pull
the two halves gently apart, (Fig. 6.60).
note: If you have any questions on the use and
operation of the pelvic restraint belt, the please contact
your wheelchair dealer, carer or attendant.
warnIngs!
• The pelvic restraint belt must only be fitted or adjusted
by an approved Sunrise Medical dealer / agent.
• The lap belt must be checked on a daily basis to
ensure it is adjusted correctly and it is free from any
obstruction or adverse wear.
• Sunrise Medical does not recommend the
transportation of a person in a vehicle with the pelvic
restraint belt as a restraint system.
See the transit brochure from Sunrise Medical for
further information on transportation.
maintenance:
Check lap belt and securing components at regular
intervals for any sign of fraying or damage. Depending on
usage, it may need to be replaced.
warnIng!
The pelvic restraint belt should be adjusted to suit the end
user as detailed above. Sunrise Medical also
recommends that the length and fit of the belt is checked
on a regular basis to reduce the risk of the end user
inadvertently re-adjusting the belt to an excessive length.
Fig. 6.57
Fig. 6.58
Fig. 6.59
Fig. 6.60
24