Table of Contents
Advertisement
backrest
To adjust the back angle, please undo the Allen screw (1)
and remove it. Set the desired position and then refit the
screw in this position and tighten it to the given torque
(Fig. 6.27).
folding backrest
To make it easier to transport the wheelchair, the top half
of the backrest can folded down.
To do this, press both levers (1) and fold the backrest
down. When folding the backrest back up, please make
sure that both sides are firmly interlocked (Fig. 6.28/6.29)
adjustable back-sling
The adjustable back-sling can be adjusted for tension by
using several straps. The back sling upholstery can be
accessed from the inside via an opening and can be
padded to suit individual tastes, (Fig. 6.30).
height-adjustable backrest
The backrest may be set to various back heights, in 2.5
cm steps (3 adjustment ranges: 25-30 cm, 30-40 cm,
40-45 cm).
Release the screw (1) and set the backrest to the desired
height Then tighten the screws again (see
the page on torque).
attentIon!
please take into account the altered centre of gravity
when setting the angle of the backrest.
headrests
headrests
The headrest (Fig. 6.31) can be raised and moved hori-
zontally both forwards and backwards.
To do this, loosen the screw (1,2 or 3).
Now you can adjust to the desired position. Tighten
screws again (see the page on torque).
Fig. 6.27
Fig. 6.28
Fig. 6.29
Fig. 6.30
1
Fig. 6.31
17
1
1
1
2
3
1
Advertisement
Table of Contents
