Power Cable Arrangement - Samsung DVM PLUS III HR Installation Manual

installing the unit
WIRING WORK
Connecting the power terminal
Examples to use cable striper
1. Adjust the blade position by coin(the controller is at the bottom side of the
tool). Fix the blade position according to the outer sheath thickness of the
power cable.
2. Fix the power cable and tool by using the hook at the top side of the tool.
3. Cut out the outer sheath of the power cable by revolving the tool in the
direction of the arrow, two or three times.
4. At this situation, cut out the outer sheath of the power cable by moving
the tool toward the arrow direction expressed.
5. Slightly bend the wire and pull out the cut part of the outer sheath.

Power cable arrangement

• Make sure all wiring should not contact with piping line during the field wiring work.
CAUTION
• Make sure to pass electrical wiring of the power cable(3 phase 3 wires) through a
Connecting the Ring terminal of 3 Phase cable(CV)
30mm(1-1/8")
1. Be sure to connect the suitable length of power wiring to the power wiring terminal block
using ring terminal above the figures.
2. Make sure to fix wiring using cable tie like above the figures.
3. After wiring, reinstall the housing cover which has an isolator into the middle frame.
34_ installing the unit
DVM PLUS3 HR_IM_E_32805-2.indd 34
If not, the vibration of compressor can make a damage to wiring and piping.
conduit hole of the front side.
A
B
Cable
A B
60mm(2-3/8")
<Cable striper>
Connecting the Ring terminal of 3 Phase cable(FCV)
Base line
A
30mm(1-1/8")
Middle frame
Base
line
A
B
B
60mm(2-3/8")
2011-11-11 오후 4:18:28