Solution Strainer - Windsor TC17/2OlFE Operating Instructions Manual

TRIDENT COMPACT 17" 230V/240V
VACUUM
MOTOR
Unplug the machlne from outlet.
2 . Remove (6) bolts holding vac motor/ plate
assembly to recovery tank.
Disconnect vac motor lead from connector
3 .
and lift out vac motor/ plate assembly.
Check motor brushes. When worn to 318" replace
4 .
both brushes.
After the machine has been used for any wet pick-up,
allow the vacuum motor to run
duce moisture build-up in the vacuum motor. Drying
out the vacuum motor after each use will extend the life
of your vacuum motor.
Hazardous Voltage. Shock can result. Unplug
mahcine before servicing machine. Only
qualified personnel should work inside ma-
chine.
Wire Terminal
Replace carbon vac motor
brushes if worn down to
length. These brushes wear
quicker as the length shortens
due to increased heat.
Spring inside brush housing
will
damage motor if brushes
are allowed to completely wear
away.
Note: Place stop
In groove.
NOTE: Periodically check the length of the carbon
brushes. ReDlace carbon brushes which 8re less
han
PART NO. 74695
minutes, to help re-
1 -2
When
replacing
carbon vac motor
brushes loosen wire
BEFORE
re-
moving screws on
bracket.
Wire
in
MAINTENANCE
BRUSH
Brush
Installation:
Slide brush or pad driver under drive plate.
2. Align one metal lug on the brush or
pad driver with the scrub deck sight hole
and a keyhole in the drive plate.
Raise the brush or pad driver upward
3 .
and twist clockwise until locked.
Brush Removal:
1. Raise brush or pad driver off floor.
2. Reach under brush or pad driver and rotate
so that the metal lug in the drive plate is
visible through the scrub deck sight hole.
3 . Quickly twist brush or pad driver counterclockwise to
release.

SOLUTION STRAINER

An inline solution strainer is located under chassis
behind left wheel. Remove sediment bowl and
careful not
Be to misplace the gasket.
Page 9 of 27
9