Table of Contents
Advertisement
TRIDENT COMPACT 17" 230V/240V
SAFE NIOPERATIONS
INSPECTION:
Carefully unpack your scrubber and
inspect it for an shipping dama
which occurred &ring shipping is
HOW IT OPERATES
The TRIDENT COMPACT is a walk-behind scrubber.
The main scrubbin components include a solution/
recovery tank, sing
e disc-type brush or pad, a rear
squeegee and a vacuum motor.
Detergent solution and water flow from the solution
tank to the scrub brush. The rotating brush scrubs the
floor. As the machine moves forward, the rear squee-
gee collects the dirty solution and channels
vacuum of the squeegee pickup hose. The pickup
hose deposits the dirty solution into the recovery tank.
PREPARING FOR OPERATION
(PERFORM DAILY MAINTENANCE AS SHOWN ON
Fill Solution Tank
Remove cover and
(see item
fill.
1
a clean bucket or hose
Use
2.)
with water.
~-
Water which
too hot may distort the polyethyl-
C).
is
ene
tanks.
Add a cleaning concentrate
3 . )
floor scrubbers. Closely follow the manufacturer's instruc-
tions
container. Read ingredients
found on
container to ensure compatible chemicals are used.
Use only the suitable chemicals listed below.
Using incompatible chemicals may damage
the machine. Dama 8s of this type are not cov-
tion Plan. Carefully read ingredients on
manufacturer's label before using any product
in this machine.
SUITABLE
INCOMPATIBLE
CHEMICALS
CHEMICALS
Alkalis
Aldehydes
Defoaming Agents
Carbon Tetrachloride
Detergents
Chlorinated
Methyls
Hydroxides
Phenols
Trichlorethylene
D-Limonene
Any damage
e
into the
it
page
19,
14)
the tank
to fill
of 140" F(60"
use
automatic
for
in
listed on the
Hydrocarbons
(MEK)
PREPARING FOR OPERATION (Cont.)
Plug the power cords together
4 . )
locked position. Attach the power cord
strain relief
as
shown. Plug power cord into
grounded wall outlet.
Turn vacuum motor switch on and off to make
5.)
is
sure there
electrical power at machine.
OPERATING THE MACHINE
ON
PAGE 8.)
to be scrubbed should be swept, dry
mopped and clear of debris (paper plates,
cups, etc.).
Adjust the operator control handle to a
2.
comfortable position. (see item 3, page 7)
3 . Release solution. (Pull solution control lever
rearward.) (see item 6, page
amount of solution can be regulated during
operation depending on the Zype
the traverse speed of the machine. Pulling the
lever farther rearward releases more solution.
Switch on brush drive motor. (see item
4.
Switch on vacuum motor. (see item
5.
6.
Lower scrub deck. Pull scrub deck
rearward. (see item
8.
not leave brush running on floor whlle ma-
Do
chine is stationary.
Lower squeegee. Pull squeegee lift lever
7.
back. (see item
page
7,
7)
squeegee
as
shown on page
8.
Move machine forward by applying even
pressure on the main handle. Forward motion
is assisted by the scrubbing action of the
- +-----
rke extra care not to run machine over cord
or catch cord on squeegee when turning.
9.
Plan your cleaning route to work away from
the electrical source. Move machine forward
at a steady pace.
Page 6 of 27
and
to the yellow
a properly
NOTE The
7)
of floor and
page
2,
7)
lever
NOTE Adjust
10.
-
-
Advertisement
Table of Contents
