General Feature Codes For System Setting; Static Ip Configuration - SunComm SC-1695i User Manual

3.2 General Feature Codes for System Setting

Dial numbers Features
*114# Play the phone NO.
*115# Check the TT number of gateway (using just when the device interconnects
*150*a# Set IP address(static/DHCP), a can be digit 1 or 2,*150*1# is static IP
*152*a*b*c*d Configure IP address, a, b, c, d are the four fields of IP address.
*153*a*b*c*d Configure subnet mask. a, b, c, d are the four fields of the subnet mask
*156*a*b*c*d Configure the device gateway, a, b, c, d are the four fields of the device
*158# Report the IP address
*157 Setting the work mode (route or bridge), * 157 * 0 # is route mode, * 157 *
*195# Play record
*198# Clear record
*199# Setting Record. dial*199# start record(≤ 20s), then press # end the
*111# Restart device

3.3 Static IP Configuration

This chapter introduces IP configuration of SC-1695ithrough calling IVR.
Assuming the IP address of a SC-1695i device is 192.168.1 200, subnet mask is 255.255.255.0, IP
of gateway is 192.168.1.1, configured as follows:
1) Please make sure hardware installation have finished
2) Dial the phone number of the SIM card. Dail "*150*1#" after hearing "please dail extension
number ". Hang up after hearing "setting successful"
3) Dial the phone number of the SIM card. Dail "* 152 * 192 * 168 * 1 * 200 #"after hearing
"please dail extension number ". Hang up after hearing "setting successful"
_______________________________________________________________________________
SunComm Technologies Co., Ltd.
Table 3-3-1 Feature codes for system setting
User Manual
7