Digit Map - SunComm SC-1695i User Manual

Port Configuration
ALL ports register
used same user ID
SIP User ID
Authenticate ID
Password
Tx Gain
Rx Gain
To VoIP Hotline
To PSTN Hotline
Auto-Dial Delay Time

4.13 Digit Map

_______________________________________________________________________________
SunComm Technologies Co., Ltd.
Table 4-12-3 Description of Port Configuration
Used to configure ports' gain, Auto-Dial, etc.
The default is not. If set to "yes" ,all the port will use user ID
It is the account used for registration, equipment port's unique identifier
Used for authenticate
Its register Password
Its DSP's Tx Gain. Adjusting it will effect volume on GSM side.
Its DSP's Tx Gain. Adjusting it will effect volume on IP side.
When PSTN part client calls to this port, gateway will auto forward to
the hotline User ID. Leave it blank if you don't need this function.
*Note: Please config Tel->IP Operation if you need this function.
When VoIP part client calls to this port, Gateway will auto forward to the
number to PSTN part. Leave it blank if you don't need this function.
*Note: Please config IP->Tel Operation if you need this function.
The auto-dial delay time of hotline , the range is 0-10 seconds
Figure 4-13-1 Digit map
User Manual
45