Maintance - LawnMaster CLGT1018B01 Operator's Manual

MAINTANCE

W A R N I N G
before adjusting, inspecting, or cleaning the grass trimmer.
Cleaning
Remove the battery pack.
1. Brush or blow dust and debris out of the air vents using compressed air or a vacuum. Keep
the air vents free of obstructions, sawdust, and wood chips. Do not spray, wash, or immerse the
air vents in water.
2. Wipe off the housing and the plastic components using a moist, soft cloth. Do not use strong
solvents or detergents on the plastic housing or plastic components. Certain household cleaners
may cause damage, and may cause a shock hazard.
Battery Pack
Recharge the battery pack whenever there is less power. Do not allow the battery pack to be
come completely discharged.
Once the charging light turns green, remove the battery from the charger and disconnect the
charger from the outlet.
Recharge the battery at a temperature of between 32 and
pack is hot, allow it to cool down before recharging.
After charging, the battery pack may be stored in the charger, as long as the charger is not
plugged in.
Charger Maintenance
Keep the charger clean and clear of debris. Do not allow foreign material to get into the re
cessed cavity or onto the
vents or water, and do not place the charger in wet conditions.
Fully charge the batteries before placing them in storage. Do not recharge a fully charged bat
tery pack.
Recharge the battery pack whenever there is less power. Do not allow the batteries to become
completely discharged.
Store the charger at normal room temperature. Do not store it in excessive heat. Do not use
the charger in direct sunlight. Recharge at room temperature between 50 and
contacts. Wipe the charger clean with a dry cloth. Do not use sol
22
r.
(0 and If the battery
(10 and