Troubleshooting - Icom IC-M34 Instruction Manual

10

TROUBLESHOOTING

PROBLEM
The transceiver does not turn
ON.
No sound from speaker.
Transmitting is impossible,
or high power can not be se-
lected.
The displayed channel cannot
be changed.
Scan does not start.
No beep.
Battery voltage error.
26
POSSIBLE CAUSE
• The battery is exhausted.
• The battery pack is not attached cor-
rectly.
• Squelch level is too high.
• Volume level is too low.
• Speaker has been exposed to water.
• Some channels are for low power or re-
ceive only.
• The battery is exhausted.
• The battery over charged.
• The output power is set to low.
• Lock function is activated.
• "TAG" channels are not programmed.
• Beep tone function is turned OFF.
• The connected battery pack's voltage is
more than 11 V.
SOLUTION
• Recharge the battery pack.
• Attach the battery pack correctly.
• Set squelch to the threshold point.
• Push [Y]/[Z] after pushing [VOL] to set
a suitable level.
• Drain water from the speaker.
• Change channels.
• Recharge the battery pack.
• Verify the battery voltage is correct.
• Push [H/L] to select high power.
• Push and hold [LOCK] (H/L) for 1 sec.
to cancel the function.
• Set the desired channels as "TAG" chan-
nels.
• Set the beep tone to ON (Fix Beep/User
Beep) in set mode.
• Verify the battery voltage is correct.
REF.
p. 23
p. 3
p. 12
p. 11
p. 13
pgs. 8,
9, 27
p. 23
—
p. 10
p. 12
p. 15
p. 18
—