Operation - Whistler WIC-5000 Owner's Manual

WIC-5000man.qxp 11/27/2012

Operation

1. Press the power switch to turn the camera on (refer to Fig-1). The power
indicator will illuminate and the LCD will become viewable.
2. If the image on the LCD is unclear, try adjusting either the brightness,
contrast or mirror controls on the monitor.
LEDs Brightness Control:
pressing the LEDs Brightness Control button (refer to Fig-2).
LCD Contrast Control:
pressing the LCD Contrast Control button.
3. To rotate the orientation of the image displayed on the LCD by 90 degrees,
press the Mirror button. There are four (4) possible image orientations that
you can toggle through by pressing this button.
4. When in use, the tube should easily maneuver itself into position. Do not
apply excessive force (refer to Fig-3).
5. The accessories included with the unit can be used to retrieve small items like
dropped rings, screws or grabbing wires (refer to Fig-4).
TIP!
The flexible tube can be bent to accommodate exploration in a variety of locations.
IMPORTANT!
Do not immerse the monitor in water. Store in a dry place. Such measures
reduce the risk of electric shock and damage. Only the lens and tube are water resistant
when the unit is fully assembled.
2:48 PM Page 4
The 6 levels of LED brightness can be adjusted by
The 8 levels of LCD contrast may be adjusted by
LEDs
Provide Illumination
Fig 2
4
Fig 4