Repeating Registration; Installation - Siemens Gigaset Instruction Manual

Installation

Repeating registration

You can reregister the Gigaset Repeater at any time, for example if initial registration was
unsuccessful, or if the Gigaset Repeater is to be registered at another base station for the
first time.
Before registering the Gigaset Repeater once again (e.g. at a different base station), please
reset the Gigaset Repeater beforehand as described below:
$ Switch off the unit (disconnect the power plug)
●
$ Switch on for 1 to 5 seconds and switch it off again
●
$ Switch on for 25 to 35 seconds and switch it off again.
●
The Gigaset Repeater is now ready to be registered again as described above. This is sig-
nalled by the LED which flashes continually once the power plug is reconnected.
Installation
Once you have registered your Gigaset Repeater you can install it wherever you would like
to extend the reception range of your handsets. However, you must ensure that there is a
power point at the place of installation and that the left LED remains on constantly after
the device has been switched on.
If the left LED flashes, the Gigaset Repeater is too far away from the base station or recep-
tion is being hindered by thick walls or metal objects for example (e.g. radiators).
When looking for a suitable installation site, a useful guide is a handset which requires a
good connection with the base station at the Gigaset Repeater installation site.
To operate a handset for the first time in the extended Gigaset Repeater area, switch off
the handset within the new reception range of the Gigaset Repeater, but outside the
reception range of the base station and then switch it back on again:
If you are using more than one Gigaset Repeater in the area of your base station,
you must keep the Gigaset Repeaters at least 10m apart.
14
Base station
Extended reception area