Download Print this page

Siemens Gigaset Instruction Manual page 4

Hide thumbs

Advertisement

Socket
for
power
lead
Preparing
Please refer to the user guide for your phone to check whether your base station is suitable
for operating the repeater and how to prepare it for registering the repeater.
Registration
Carry out the following steps:
Ensure that other base stations close to the Gigaset Repeater are not in registra-
tion mode during this process.
The Gigaset Repeater can be registered independently of the length of an au-
dible registration tone or a display at the base station.
If registration is not successful, the LED on the Gigaset Repeater will flash
continuously. In this case, repeat the procedure.
The power lead supplied is plugged into the socket
on the Gigaset Repeater's rear side. Using the speci-
fied measurements, drill the necessary holes in the
wall to mount the device using the screws and plugs
supplied.
The different operating modes are indicated on the
front of the Repeater unit by means of two LED's (for
an explanation, see page 15).
LED's
Switch off the Gigaset Repeater (disconnect the po-
$
wer plug).
Place the base station in Repeater registration
mode in the same way as you would to manually
register a handset. Please refer to the operating in-
structions for your base station.
$
Switch on the Gigaset Repeater (connect the power
plug).
The left LED on the Gigaset Repeater flashes conti-
nually. After a short while the LED stays on perma-
nently indicating that registration is complete and
that the unit is ready for operation.
Preparing
13

Hide quick links:

Advertisement

loading