Repeating Registration - Siemens Gigaset Repeater Setup & User Manual

Preparing
Please refer to the user guide for your phone to check whether your base station is suitable
for operating the repeater and how to prepare it for registering the repeater.
Registration
Carry out the following steps:
Ensure that other base stations close to the Gigaset Repeater are not in registra-
tion mode during this process.
The Gigaset Repeater can be registered independently of the length of an au-
dible registration tone or a display at the base station.
If registration is not successful, the LED on the Gigaset Repeater will flash
continuously. In this case, repeat the procedure.

Repeating registration

You can reregister the Gigaset Repeater at any time, for example if initial registration was
unsuccessful, or if the Gigaset Repeater is to be registered at another base station for the
first time.
Before registering the Gigaset Repeater once again (e.g. at a different base station), please
reset the Gigaset Repeater beforehand as described below:
$ Switch off the unit (disconnect the power plug)
●
$ Switch on for 1 to 5 seconds and switch it off again
●
$ Switch on for 25 to 35 seconds and switch it off again.
●
Switch off the Gigaset Repeater (disconnect the po-
$
wer plug).
Place the base station in Repeater registration
mode in the same way as you would to manually
register a handset. Please refer to the operating in-
structions for your base station.
$
Switch on the Gigaset Repeater (connect the power
plug).
The left LED on the Gigaset Repeater flashes conti-
nually. After a short while the LED stays on perma-
nently indicating that registration is complete and
that the unit is ready for operation.
Preparing
11