Saeco Atlante 500 Use And Maintenance Manual page 49

DISPLAY
1.13.
Cup Management
1.13.1.
Cup Dispenser
1.13.1.1.
Enable
1.13.1.2.
Cup stock
1.13.1.3.
Cup device stop delay
1.13.2.
Disp. outlet micro
1.13.3.
Cup Sensor
1.13.3.1.
Enable
1.13.3.2.
Set1=no cup
1.14.
Sugar
1.14.1.
Cup Sugar Delay
Description
Cup dispenser settings.
It enables using the cup dispenser.
It sets the number of cups left in the dispenser when the refill microswitch for the following
cup column has to be activated.
Delay between the time when the cup column falls into the vending machine slot and when
the column motor stops.
Allows cup detection inside the dispensing outlet. When checking is enabled, dispensing new
products is not allowed until the paper cup of the previous beverage is still inside the outlet.
Removal is detected by the photoelectric cell (if any) or by opening the dispensing outlet.
Important
If you wish to use the VM with the dispensing door always open, it is necessary to
short-circuit the wiring of the dispensing outlet microswitch.
(Optional kit)
Enables management of the cup sensor.
It enables the cup sensor.
It enables the function that allows to dispense beverages that have different prices if they are
dispensed with or without the cup.
Important
The Set1 = No cup option shall be used to set a discount for beverages dispensed without
the cup. The machine does not allow to set discounts on the prices but the same result can
be achieved by using the second beverage set and setting the reduced price and
deactivating the cup dispensing for this set.
To save you from copying the recipes of the standard set to set 1, you can select a mode
that, in case of beverages without cup, automatically uses the recipes of the standard set
and the prices of set 1.
You only need to:
programme the beverage standard set with the desired products by setting for each one the
price with the cup included;
set the price of the corresponding beverages of set 1 to the desired value for the sale
without cup (set only the prices, the machine does not need the recipes and all other
beverage parameters of set 1 including the exclusion of the cup);
enter the "System Management" menu and within the cup settings set to YES the "Set1=no
cup" option;
set the mode for selecting beverages without cup. Set the "Set 1 Pre-Selection" option to
pre-selection and/or enable cup sensor (optional kit).
Sugar dispensing settings.
Minimum delay between the time when the cup is dispensed and when the movable sugar
chute moves.
English
49