Safety Devices; Residual Risks - Saeco Atlante 500 Use And Maintenance Manual

Supply operator
The Maintenance Technician assigns the safekeeping of the
access key to the Supply operator who is in charge of
product supply, external cleaning, and starting up /
stopping of the vending machine.
The Supply Operator is not authorized to carry out
operations which are indicated as being the duties of
the Maintenance Technician in this publication.
Maintenance Technician
The Maintenance Technician is the only person authorized to intervene
and start programming procedures, and perform adjusting, setting up and
maintenance operations on the vending machine.
Access to the service area is restricted to persons having knowledge
and pratical experience of the appliance, in particular as far as safety
and hygiene are concerned.
3.4

Safety devices

The vending machine is equipped with:
• a safety switch which cuts out the voltage to all the inside
components any time the front door is opened.
• a safety switch located on the dispensing outlet door,
which blocks the nozzle arm cycle whenever the door is
opened.
IS Safety switch
Maintenance Technician
In case of programming or setting up operations only the
Maintenance Technician can intervene by inserting the
relevant key into the safety switch and resetting the
voltage even if the door is open.
This operation, necessary for starting up the vending
machine, disables the safety system.
It must therefore be carried out by qualified personnel
(Maintenance Technician) aware of the risks resulting
from the presence of live or moving components.
3.5

Residual risks

The dispensing outlet is protected by the door interlocked
by the safety switch.
If it is opened during the brewing cycle, mechanical
movement is blocked, but if brewing has already started, it
continues up to the end of the cycle.
Risk of scalding if hands are placed inside the outlet
during brewing.
It is forbidden to open the door and take out the cup
or put hands inside the outlet during dispensing,
before the brewing cycle is complete.
Before removing the cup from the outlet, please wait
for the message "REMOVE CUP" on display.
If the outlet door is opened during the brewing cycle,
the message "CLOSE SERVICE DOOR" will be
displayed; the nozzle arm stops and will not restart
until the door is closed.
It is not possible to brew further beverages if the
previous cup is not taken out (see the "Dispensing
outlet microswitch" menu item).
Before brewing another beverage, check that the
previous one has been taken out and that the cup
support is empty.
English
21