Saeco Atlante 500 Use And Maintenance Manual page 56

English
DISPLAY
3.3.
Beverage 1
... The possible choices are:
3.3.
Beverage 1 1 = dispenses product 1
Sequence 0C00 2 = dispenses product 2
3.3.
Beverage 1 The quantity of dispensable coffee can be adjusted from "1" to "999".
H2O / Coffee 38
3.3.
Beverage 1
Just water 101
3.3.
1 The value can be set between 10 and 100. The lower the value the smaller the powder
Beverage
% Instant product 3:50
3.3.
Beverage 1 The value can be set between 20 and 100. The lower the value the smaller the water
% Pump 3:50
3.3.
Beverage 1
Instant Dose 3:005 Example: "005" quantity indicates that the motor of the instant product 3 will be activated
3.3.
Beverage 1
H2O / instant 3:022 Example: "3" indicates that water will be mixed with the instant product 3. "022" indicates that 22 units of water
product
56
Description
This is the order in which the products making up the beverage are brewed.
0 =does not dispense any product
3 = dispenses product 3
4 = dispenses product 4
5 = dispenses product 5
6 = dispenses product 6
7 = dispenses product 7
8 = dispenses product 8
C = dispenses coffee beans from coffee hopper no. 2
K = dispenses coffee beans from coffee hopper no.1
W = dispenses hot water
S1 = dispenses syrup product 1 (optional)
S2 = dispenses syrup product 2 (optional)
Consequently, the combination of "3C00" or "30C0" or "03C0" will always dispense
product 3 and coffee beans. The settings of products making up the beverage will be
requested according to the sequence.
Important
To obtain the cup only, set beverage sequence to 0000 and block sugar regulation (sugar
setting = "sugar blocked").
This defines the quantity of coffee to be brewed.
Defines the amount of hot water to be dispensed.
It determines the instant powder delivery rate.
delivery rate.
It determines the water delivery rate.
delivery rate.
Important
The % pump parameter is displayed only on the machines without instant product boiler.
If the sequence includes several instant products, the sequence "INSTANT PRODUCT - WATER -
DELAY INSTANT PRODUCTS - % OF INSTANT PRODUCT" will be shown again.
If the setting relative to the instant product ("INSTANT PRODUCT - WATER") means that
the powder dispensing lasts longer than the water dispensing, the vending machine stops
powder dosing (to avoid insufficient rinsing of the mixer) and emits a beep. Readjust the set
parameters in order to have a correct dispensing procedure, i.e. the powder dispensing
should stop a few seconds before the water stops flowing out. This is intended to allow
correct mixer washing.
This defines the quantity of instant product to be brewed.
for 5 tenths of a second. The quantity of instant product is adjustable from "1" to "100" in
steps of 1. Brewing of the instant product does not occur when the parameter is set at
"0000" (in this case water is brewed).
It defines the amount of water to be mixed with the instant powder.
will be brewed with the instant product. The reference unit is preset by the manufacturer. The amount of water
can be adjusted from ' " 1" to "999" in steps of 1.