Indicators; Quad Docking Station Operation; Charging The Omnii Battery; Installation - Motorola Omnii User Manual

5 - 16 Omnii (Windows Embedded Hand-Held 6.5) User Guide

Indicators

The quad docking station is equipped with Ethernet activity and link LEDs (see
connection on page

Quad Docking Station Operation

Charging the Omnii Battery

• Insert the DC power plug into the ST4004 rear DC IN connector (see
connection on page
IMPORTANT
The ST4004 supplies DC power to enable the Omnii internal fast charger. Normally, a full charge of the battery
will take from 3 to 4 hours.
• Insert up to four Omnii computers into the docking station charging bays, pressing down gently but firmly to
seat them securely.
• During the charge, the Omnii LED slow flashes green.
• When the battery finishes charging, the LED turns solid green.
• To remove Omnii, push down on the release mechanism on the front face of the docking bay. The
hand-held will detach from the docking bay release arms and can be pulled up and out.
NOTE
Battery charging continues whether Omnii is switched on or off.
Insertion and removal of Omnii computers
Figure 5-13

Installation

Place the charger in an area that is free from excessive dirt, dust, water and other liquids, and contaminants.
The ambient temperature must be in the range 0° C and 40° C (32° F to 104° F). The docking station will not
charge batteries outside of this temperature range. For maximum performance, it is recommended that the
charger be operated at room temperature — a temperature range between 18°C to 25°C (64°F to 77°F).
5-17).
5-17).
Use IEC-320 C13 power cords approved by Motorola, with the ground pin
connected to a proper earth-grounded receptacle. Check with a qualified
electrician if you are uncertain of your receptacle grounding.
Figure 5-14 Ethernet network
Figure 5-14 Ethernet network
Release arm
Release mechanism