REMOVING THE BLOWER MOTOR ASSEMBLY
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so could result in death or
electrical shock.
CAUTION: When you work on the microwave
oven, be careful when handling the sheet metal
parts. Sharp edges may be present, and you
can cut yourself if you are not careful.
1.
Disconnect the electrical power to the
microwave oven.
2.
Remove the microwave oven assembly
from its mounting location (see page 2-2
for the procedure).
3.
Remove the top rear cover (see page 2-5).
4.
Position the microwave oven assembly
with the back facing you.
5.
Remove the two top screws from the rear
cover and remove the air vent cover.
Screw Air Vent Cover Screw
6.
Remove the four screws from the blower
cover and remove the cover.
2 Screws
7.
Disconnect the two wires from the blower
motor terminals.
2 Wires
8.
Remove the two screws from the blower
mounting bracket and remove the bracket
and blower.
9.
Remove the four mounting screws from
the blower motor assembly and remove it
from the bracket.
4 Blower Motor Assembly Screws
2-7
Blower Cover
Blower Motor
Blower
Mounting
Bracket
Screw
(1 of 2)
Blower Motor Assembly
2 Screws