REMOVING THE MICROWAVE OVEN
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so could result in death or
electrical shock.
CAUTION: When you work on the microwave
oven, be careful when handling the sheet metal
parts. Sharp edges may be present, and you
can cut yourself if you are not careful.
1.
Disconnect the electrical power to the
microwave oven.
2.
Remove the oven control assembly (see
page 2-3 for the procedure).
3.
Remove the three air vent screws and
remove the air vent.
Air Vent
Air Vent Screws
4.
Remove the two screws from the bottom
air vent and remove the vent.
Bottom Air Vent
FROM THE OVEN CABINET
Screw (1 of 2)
2-8
5.
Remove the two screws from the lower
microwave mounting brackets.
Lower Microwave Bracket Screws
6.
Pull the microwave oven out of the oven
cabinet approximately four inches.
7.
Disconnect the two red LOAD wires from
the light power supply, the 6-pin connec-
tor, and the green ground wire in the top of
the oven cabinet.
6-Pin Connector
Ground Wire
Light Power Supply