Group 23 >>> Codabar Coupling - ID Tech EconoScan Manual

-- GROUP 23--
SYMBOLOGIES FORMATING:
CODABAR COUPLING, ADJACENT MUST ON .
. I 019$
ON
. I 020$
OFF
. I 021$
SET INSERT DATA*
ABC-CODABAR and CX-CODABAR code have certain rules of
Stop Character of first bar code and the stop character of Second
bar code while conjunction, but CODABAR COUPLING does not
have any limitation of that, means that while CODABAR COUPLING
is on, You can couple whatever TWO Codabar into one data set of
data without any limitation between the Stop character of first
bar code and the Start character of Second bar code. Both bar code's
Start and stop will be sent.
. I 033$
. I 034$
REMARK:
1.You can enable both ABC-Codabar and CX-Codabar together except
Codabar-Coupling.
2.If ABC-Codabar , CX-Codabar, Codabar-Coupling are on together,
the scanner will read only Codabar Coupling, either ABC- Codabar
or CX-Codabar will be considered as Coupling-Codabar format.
SETTING PROCEDURE - SET INSERT DATA
Step 1- Scan " Set Insert Data ".
Step 2- Scan any data from Full ASCII ( Code39 ) table. The data
can be any characters or alphanumeric from Group 32-40)
Step 3- Scan " Set Insert Data ".
RESET
.If any setting steps are not accomplished as above mentioned
setting procedure, the scanner will beep a long beep " Ti", "Ti",
"Ti" to remind you. Please go on to complete the setting OR
Scan RESET for resetting.
*The data can be any alphanumerics of FULL ASCII Table ( GROUP 32- 40 )
ON
OFF
. P023$
35
CODABAR COUPLIN
. I 041$
INSERT DATA -ON
. I 026$
INSERT DATA- OFF
ADJACENT REQUIRED
If CODABAR ADJACENT is
set to on, the scanner read-only
Couple ( TWO ) CODABAR.
Codabar which is in " Singer"
will not be able to read.