APPENDIX 1
FULL ASCII ( Code 39 ) NUMERIC TABLE
0
2
4
6
8
SETTING PROCEDURE
MIN / MAX LENGTH (Default Length)
STEP 1 - Scan: MIN / MAX LENGTH
STEP 2 - Scan : " TWO DIGIT " Number
STEP 3 - Scan: MIN / MAX LENGTH.
Be noticed that the scanner will only read a bar code within the length's limit. Any
bar codes which the length out of limitation range will not be read. The Default's
lengths of symbologies are marked clearly at the column after Min/Max Length.
1.Min Length & Max Lengths need Triple Setting.
2.If any setting steps are not accomplished as above mentioned
setting procedure, the scanner will beep a long beep " Ti", "Ti",
"Ti" to remind you. Please go on to complete the setting.
3.Suppose you made a mistake, or lose your place while setting,
s
cans RESET (. P023$) at below for resetting.
RESET
1
3
5
7
9
from Appendix 1.
. P023$
27