Cloning Mode - ID Tech EconoScan Manual

CLONING MODE

WHAT IS CLONING MODE?
CLONING means duplicate a parameter's setup of a scanner to the
other's scanners. It can save much time for lots scanner setting.
HOW SHOULD THE CLONING WORK?
Step 1 : Take a scanner, set all the parameters with this manual.
Step 2 : Scan the CLONING MODE bar code shown at Figure 1.
Step 3 : O nce CLONING MODE is Scanned, all setup parameter will be
converted into alphanumeric and throw it to the monitor.
Step 4: Use your bar code printer, print out all the value ( data values
are shown on the monitor.)
Step 5 : Scan the printed label form up to down sequentially with the
scanner which is need to program..
.
. A016$
. A018$
.A018$( Cloning Mode on PC/AT) - you can clone the settings to a PC/AT
regardless what kind of device has been chosen on the scanner
REMARK:
1. All strings are in upper cases.
2. All Cloning string which printed into labels should same to what
are shown on the monitor sequentially from 1st row to the end.
3. The CLONING MODE can be work in the Word, Note Pad Only.
4. The bar code of cloning label is Code 39 (No CDV).
5. Never edit data at first row (.A017$). It is an enter gate for cloning.
6. You can adjust the cloning string's length by combined multiple
strings into one or breaking one string to multiple strings starting
from Second Row after "....". , Note: the length must be in the
sequences of 4 ( FOUR); Such as 4,8,12,16,20(MAX).
7. Be aware of do not omit to print the dot which should same exactly
as what are shown on the monitor.
.
FORMAT OF CLONING FORMAT OF CLONING
* Format of Cloning :
1st rows >>> ".A017$" ( never edit any data of the first row )
2nd rows >>> "....XXXX" you can adjust the String's Length starting
from the dots"...." forward. The length of the string should
be in 4, 8,12,16 or 20 ( MAX )digits.
3rd rows~ so on >>> XXXX
End rows- A dot "." Is an ending of cloning.
XXXX Stand for any String
Into CODE 39 label.
CLONING MODE
CLONING MODE ON- PC/AT
4
Figure 1