Codabar Coupling - ID Tech Ez One Shot User Manual

Hide thumbs

Table Of Contents

Table of Contents

SYMBOLOGIES: CODABAR COUPLING, ADJACENT REQUIRED

. I 019$

. I 020$

OFF

. I 021$

SET INSERT DATA*

ABC-Codabar and CX-Codabar have certain rules regarding

the Stop Character of first bar code and the stop character of

second bar code while in conjunction, while Codabar-

Coupling is enabled, the data from any two Codabar bar codes

can be coupled into one set of data without any limitations

between the Stop character of first bar code and the Start

character of second bar code. The Start and Stop characters

associated with each bar code will be sent.

The data can be any alphanumerics of FULL ASCII Table (GROUP

52-60)

ADJACENT REQUIRED

If CODABAR ADJACENT

is enabled, the scanner

will only read two adjacent

Codabar bar codes; a

single bar code will not be

read.

NOTES:

1. Both ABC-Codabar and CX-Codabar can be enabled together,

except when Codabar-Coupling is also enabled.

2. If ABC-Codabar, CX-Codabar, and Codabar-Coupling are all

enabled at the same time, the scanner will read only Codabar-

Coupling, that is, ABC-Codabar, CX-Codabar will be considered

coupling formats.

SETTING PROCEDURE - SET INSERT DATA

Step 1- Scan SET INSERT DATA.

Step 2- Scan any combination of alphanumeric characters from

FULL ASCII Table.

Step 3- Scan SET INSERT DATA.

NOTES:

1. The scanner will beep three times as a reminder that a

setting is not yet complete.

2. If you make a mistake, forget a step, etc., Scan RESET to

start again.

GROUP-43