Group 2 >>>> Reading Mode Setting - ID Tech EconoScan Manual

-- GROUP 2 --
READING MODE SETTING
. F005$
CONTINUOUS MODE
. F001$
FLASH MODE
. F002$
TRIGGER MODE
. F006$
CONTINUOUS AUTO OFF
. F003$
TOGGLE MODE
. F007$
*AUTO SENSING MODE
. F008$
*ULTRAVIOLET MODE
. F004$
TEST MODE
REMARK:
1.For extends the scanner's life time, Please set the scanner into Trigger
or Continuous Auto Of Mode.
2 Be informed that only few models support for Auto-Sensing Mode or
Ultraviolet Mode.
3.Please prints out the Ultraviolet Mode (.F004$) with A Bar code printers,
put the Ultraviolet Setting code near the working station, Scan Ultra
violet if you need it,
4.Ultraviolet Mode Converse - Press the trigger button, The reading mode
will swift from Ultraviolet Mode to the Reading Mode that you left last.
* Autosensing Mode and Ultraviolet Mode are available only for certain Model.
.
* LED is always on. ,
* The trigger is functionless eternally
if Continuous Mode on.
* LED is always on if bar codes close to
the scanner, and turns to flashing when
there is no any bar code approaching
after 60 sec.
* Trigger is in function.
* The LED will be switched on if
button.is triggered.
* The LED will be switched off when the
switch button is released.
* LED is always on when switch is pressed .
( Switch is no function when LED on )
.
* LED will be switched off automatically
when there is no bar Code approaching
approximately after 60 Sec. .
* This function works as well as trigger Mode,
but "GOOD READ" beeps after encoding.
* If Auto- Sensing ( Triggerless.) is on, LED
will be turned off if the scanner does not
detect for a bar codes..
* LED is lighted up automatically while
a bar code is detected.
* If an Ultraviolet Mode is on, Ultraviolet
light will be lighted up ( Continuously.).
* The Ultraviolet will be turned off if
ONE push of a trigger, and back to the
mode that you left last.
* Factory Test
Scanning
10
switch