Reading Mode - ID Tech Ez One Shot User Manual

GENERAL SETTINGS - READING MODE
. F005$
CONTINUOUS MODE
. F001$
FLASH MODE
. F002$
TRIGGER MODE
. F006$
CONTINUOUS AUTO OFF
. F003$
TOGGLE MODE
. F007$
*AUTO SENSING MODE (CCD)
. F010$
*AUTO SENSING MODE (Laser)
NOTES:
1. To extend the scanner's life, keep the scanner set to Trigger Mode or
Continuous Auto Off Mode.
2. The LED indicator will glow for GOOD READ.
3. For advanced settings of Auto-Sensing Mode(such as Deactivation Time,
Magnetic Switch and Blue LED) please refer to the next pages.
GROUP-2
LED is always on.
The trigger does not function in
Continuous Mode.
The LED is on steady if a bar code is
close to the scanner, but starts flashing
if no bar code is detected after 60
seconds.
The trigger does not function in Flash
Mode.
The LED will light when the trigger is
pressed.
The LED will go off when the trigger is
released.
The LED is always on when the trigger
is pressed.
The LED will go off if no bar code has
been detected after 60 seconds.
The LED is always on when the trigger
is pressed.
The LED will go off if one bar code is
read.
If Auto-Sensing Mode(CCD) is on, the
LED will go off if no bar code is detected
after Deactivation Time elapses.
(The default is 3 sec.)
The LED lights automatically when a BAR
CODE is detected.
If Auto-Sensing Mode(Laser) is on, the LED
will go off if no barcode is detected after
Deactivation Time elapses.
(The default is 3 sec.)
The laser emits automatically when an
OBJECT is detected.