Baracoda Advanced Features; Switch On Delay; Shutdown Timers - Baracoda D-Fly Programming Manual

BD-Fly – Programming Guide
1.2.

Baracoda advanced features

1. 2. 1. Sw it ch on de lay
In order to switch on the D-Fly in its standard mode, you should just press the trigger. You can set up the
scanner to be switched on only after keeping the trigger pressed for two (2) seconds by reading the
appropriate barcode.
1. 2.2 . Shut do wn t ime rs
There are two different 'shutdown timers' :
- When connected timer : delay between the last scanned barcode and the switch off when the
scanner is connected to a host
- Not connected timer : delay between the last scanned barcode and the switch off when the
scanner is not connected to any host
It is possible to set those timers to 'infinite'. In this case, the scanner will stay all the time ON.
By default, timers value are :
when connected timer = 20 minutes
Not connected timer =
June 07
Switch on delay : 2 seconds
Switch on delay : 0 second (*)
Set shutdown timers to infinity
10 minutes
Set shutdown timers to defaults
6