Baracoda BL1000 Programming Manual

BL1000
Baracoda, Inc. (US Office)
45 Main street - Suite 616 - Brooklyn, NY 11201
Ph: 718 488 9600 - Fx: 718 488 9601
The bluetooth name and Bluetooth registered trademarks are owned by Bluetooth SIG, Inc., and are used by Baracoda under license. The Baracoda names and Baracoda trademarks are
own by Baracoda. All specification are subject to change without notice - Non contractual pictures © Baracoda - All rights reserved
Programming Guide
Important notice
Every effort is made to ensure the accuracy of
our product information; however, we accept no
responsability for errors or omissions including, but not
limited to, the implied warranties of merchantability and
fitness for a particular purpose. We shall not be liable for
errors contained herein or for incidental consequential
damages in connection with the furnishing, performance,
or use of this material.
Specifications or version may be subject to change
without notice. The actual specification and version are
based on the product delivered.
Introduction
Scanning a series of programming bar code labels can
configure the scanner.
The scanner must be properly powered before program-
ming.
During the programming mode, the scanner will ack-
nowledge a good and valid reading with a short beep. It
will give long beeps for either an invalid or bad reading.
Baracoda SA (Europe Office: France)
30 Avenue de l'Amiral Lemonnier - 78160 Marly-Le-Roi
Ph: +33 1 30 08 89 00 - Fx: +33 1 30 08 89 98