Baracoda Advanced Features; Switch On Delay; Shutdown Timers; Turn Scanner Off - Baracoda D-Fly Programming Manual

1.2.

Baracoda advanced features

1.2.1.

Switch on delay

In order to switch on the scanner in its standard mode, you should just press the trigger. You can set up the
scanner to be switched on only after keeping the trigger pressed for two (2) seconds by reading the
appropriate barcode.
1.2.2.

Shutdown timers

There are two (2) different 'shutdown timers':
- When connected timer: delay between the last scanned barcode and the switch off when the
scanner is connected to a host
- Not connected timer: delay between the last scanned barcode and the switch off when the scanner is
not connected to any host
It is possible to set those timers to 'infinite'. In this case, the scanner will stay all the time ON.
By default, timers value are:
- When connected timer = 20 minutes
- Not connected timer = 10 minutes
1.2.3.

Turn scanner OFF

Supported from version v1.46. To turn off the scanner, read the following barcode:
D-Fly – Programming Guide v1.5
Switch on delay : 2 seconds
\ V T \ V T z \ N U L \ S O H \ E T X \ F F \
Switch on delay : 0 second (*)
Set shutdown timers to infinity
Set shutdown timers to defaults
Turn off scanner
F F
Data Capture
for Workforce
in Motion
- 7 -