Introduction - Baracoda D-Fly Programming Manual

BD-Fly – Programming Guide
Intro duction
The Baracoda D-Fly scanners can be programmed by scanning barcode labels which contain commands
for the decoder.
Programming labels must be Code128, with specific starting and ending characters. These labels will
always be read, even if Code128 symbology is disabled.
The scanner will acknowledge a good and valid programming barcode label reading with two beeps and a
green enlightening of the led. It will give two other beeps (lower tone) and a red enlightening of the led for
either an invalid or bad reading.
Please do not read the programming barcodes while being connected to the Baracoda Manager.
Programmable options are divided into 2 groups. The first group includes the options that show the
general behaviour of the scanner. The second group sets the decoding parameters for each barcode
symbology.
June 07 4