Connecting The Devices - Omron POWLI BN100XR Instruction Manual

● Use of 20A plug
Maximum usable capacity is the rated output capacity of the BN150XR (1500VA/1000W).
• Provide a wall outlet (commercial power) suitable for the shape of the 20A plug (NEMA L5-20).
• Replace the AC Input Plug of the BN150XR with the included NEMA L5-20 plug.
● To replace the plug
(1) Detach the 15A plug (NEMA 5-15P).
(2) Connect the NEMA L5-20 plug as shown in the diagram below.
Do not mistake the color of the wire, and affix with a screw as shown in the diagram .
3. BN240XR
● The input plug for the BN240XR is 30A (NEMA L5-30P).
When the AC input is connected directly from a power switchboard, make sure that the wiring work is
performed by a qualified electrical engineer (with Type II certfication or higher).
Wiring capacity of 30A or higher is required. (Recommended cable: nominal cross-section of 5.5mm
(AWG10) or more)
● It is possible to use a wall outlet (commercial power) with as much rated output capacity as the unpluggable
type 30A (NEMA L5-30) plug.

2-5 Connecting the devices

● Control by group of output receptacles
The output receptacles of the BN100XR/BN150XR/BN240XR are divided into three groups: A, B, and C.
1. Output receptacle A
Begins output at the same time as startup.
2. Output receptacles B and C
• It is possible to delay the start of output with respect to output receptacle A at startup.
The period of delay can be set using the included UPS monitoring software.
• While the BN100XR/BN150XR/BN240XR is in operation, the output can be switched ON/OFF by using
the included UPS monitoring software.
• The delay settings and ON/OFF control of output receptacles B and C can be set separately.
When using this function, it is possible to set the startup order of the server, peripheral devices, etc.
The connected devices can be switched ON/OFF by remote control.
L: Black wire
FG: Green wire
N: White whire
Caution
25
2. Installation and connection
2