Regency I31-NG3 Owners & Installation Manual page 9

A)02-43
Pins on Rear Log Support
4) Place Front Right Log B)02-45 on the two
pins as shown.
B)02-45
5) Place the Middle Left Log C)02-56 on the
two pins as shown.
C)02-56
Logs A)02-43, C)02-56, and
B)02-45 in position
6) Place the Left Top Log D)02-46 on the pin
on Log C)02-56 and on top of the cutout
on Log A)02-43.
Regency I31-3 Gas Fireplace Inbuilt
D)02-46
C)02-56
Pin
7) Place the notch in Center Log E)02-47 over
Log B)02-45 and across the cutout on Log
A)02-43.
E)02-47
Notch
Logs D)02-46 and E)02-47 in position.
8) Position notch in Front Right Log F)02-48
on Log E)02-47 and push the bottom right
edge against the bracket on the burner tray
and the front edge of the rear burner.
F)02-48
B)02-45
Notch
INSTALLATION
A)02-43
Side View
The bottom right edge of Log F)02-48 must sit
snugly against the bracket and the front edge
Cutout
per instructions in this manual.
A)02-43
G)02-44
B)02-45
Cutout
9) Place Front Left Log G)02-44 onto the 2 front
pins as shown.
10) Place the embers and Rockwool on the
exposed front burner tray.
11) Test fi re to ensure proper light off (make
sure fl ame fl ows smoothly from one end
of burner to the other. If there is any fl ame
hesitation, check that area for any blockage
of the burner port.
12) Install fl ush glass and optional bay glass as
C)02-56
G)02-44
Bracket
A)02-43
F)02-48
Front edge of
Bracket
rear burner
of the rear burner.
A)02-43
B)02-45
9