Table of Contents
Advertisement
WOOD
Fireplace Insert &
Hearth Heater
Owners & Installation Manual
www.regency-fire.com
MODELS:
H2100M
I3100L
Tested by:
Installer: Please complete the details on the back cover
and leave this manual with the homeowner.
Homeowner: Please keep these instructions for future reference.
FPI FIREPLACE PRODUCTS INTERNATIONAL LTD. 6988 Venture St., Delta, BC Canada, V4G 1H4
919-548
05.15.15
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Regency H2100M
Summary of Contents for Regency H2100M
- Page 1 WOOD Fireplace Insert & Hearth Heater Owners & Installation Manual www.regency-fire.com MODELS: H2100M I3100L Tested by: Installer: Please complete the details on the back cover and leave this manual with the homeowner. Homeowner: Please keep these instructions for future reference.
- Page 2 The following statements are required by the Environmental Protection Agency: “This manual describes the installation and operation of the Regency H2100 wood heater. This heater meets the 2015 U.S. Environmental Protection Agency’s crib wood emission limits for wood heaters. Under specific test conditions this heater has been shown to deliver heat at rates ranging from 10,800 BTU/hr. to 46,900 BTU/hr.”...
-
Page 3: Table Of Contents
Brick Flue Baffle & Secondary Air Tube Installation ..11 H2100 Main Assembly ..........20 Stainless smoke deflector adjustment / replacement ..12 I3100 & H2100 Firebrick ..........21 Draft Control ..............13 Screen Door ..............13 WARRANTY Warranty ..............23 http://oee.nrcan.gc.ca/residential/personal/retrofit-homes/retrofit-qualify-grant.cfm Regency Wood Insert & Hearth Heate... -
Page 4: Safety Label For I3100L
This is a copy of the label that accompanies each NOTE: Regency units are constantly being Regency Large Flush Insert. We have printed improved. Check the label on the unit and if a copy of the contents here for your review. -
Page 5: Safety Label For H2100M
This is a copy of the label that accompanies each NOTE: Regency units are constantly being Regency Hearth Heater. We have printed a improved. Check the label on the unit and if copy of the contents here for your review. -
Page 6: Installation
Electrical code, CSA C22.1. using your fireplace insert. Install and use jurisdiction. only in accordance with manufacturer’s Regency Inserts are designed to use either a installation and operating instructions. 5.5" (140mm) or 6" (152mm) flue. FIREPLACE 2) Check your local building codes - Building Inspection Department. -
Page 7: Optional Flue Connector Kit
18" (450 mm) in Canada to the front of the unit and Clearance diagram for installations 8" (200 mm) to the sides. If the unit is not raised, thermal floor protection required is 18" (450 mm) in the US and Canada. Regency Wood Insert & Hearth Heate... -
Page 8: Leg Option On H2100 Hearth Heater
Regency highly recommends the use of a full liner as the safest installation and provides the most optimum performance. Your retailer should... -
Page 9: Faceplate And Trim
5) Measure approximately the alignment of and the fireplace face. The faceplate top may the flue liner with the position of the smoke A) H2100M and I3100L Insert now be installed (with insulation strip behind) outlet hole on the insert to check for pos- by aligning its brackets with the top flange on sible offset. -
Page 10: Fan / Blower
To attach, follow the instructions provided 4) Push the Regency logo plate into the two operation. with the fan holes in the front bottom left corner of the fan. -
Page 11: Floor Protection
2) Tilt the first Baffle Brick down and then slide then replace them when cleaning is the 2nd Baffle Brick up and back. Reposition completed. both baffle bricks flat on the air tubes. Regency Wood Insert & Hearth Heate... -
Page 12: Stainless Smoke Deflector Adjustment / Replacement
To replace the deflector, loosen off both bolts and slide defector upward and out. Install new defector and hand tighten bolts. Ensure positive location of the defector prior to hand tightening. WARNING: Operation of the unit with out proper installation of smoke deflector will void warranty. 12 | Regency Wood Insert & Hearth Heate... -
Page 13: Draft Control
Lift the front end of the baffle up and over the rear of the air tube. On Hearth Heater (H2100M) Hooks Handle Lock remove center tube by sliding it sideways first and then down. -
Page 14: Operating Instructions
Two dry pieces banged together sound hollow; wet pieces sound solid and dull. • Dry wood weighs much less than wet wood. • Split a piece of wood. If the exposed surface feels damp, the wood is too wet to burn. 14 | Regency Wood Insert & Hearth Heate... -
Page 15: First Fire
Only remove ashes when the fire has died down. add two or three seasoned logs to your fire. (or in the H2100M flue baffle) starts Even then, expect to find a few hot embers. Always Form a trench in the ash bed to allow air to to glow you are overfiring. -
Page 16: Creosote
DOOR LATCH is usually not required if a proper installation 7) Your Regency Insert can be very hot. You has been done. In the event that removal is re- ADJUSTMENT may be seriously burned if you touch the quired, be sure not to damage any parts needed insert while it is operating. - Page 17 Check glass for cracks Replace if required. Clean blower motor Disconnect power supply. Remove and clean blower. *DO NOT LUBRICATE* Inspect and clean chimney Annual professional chimney cleaning recommended. Cleaning & Maintaining Your Wood Stove Regency Wood Insert & Hearth Heate...
-
Page 18: Parts List
Washer #10 Flat 45) * Bolt, 10-24 x 3/4" Black Carriage 46) 820-484 Stainless smoke Deflector 47) 846-103 I3100 Wood Screen 948-223 Regency Logo 919-548 Manual *Not available as a replacement part. 18 | Regency Wood Insert & Hearth Heate... -
Page 19: I3100 Faceplates
Black Trim Oversize (Set of 3) 395) * Trim Right Oversize 396) * Trim Top Oversize 397) * Trim Left Oversize 398) * Faceplate Side Oversize 399) * Faceplate Top Oversize *Not available as a replacement part. Regency Wood Insert & Hearth Heate... -
Page 20: H2100 Main Assembly
Yellow Insulation 48" x 4" 846-531 Faceplate Hardware Pkg. 35) 120-954 Air Tube Front 36) 120-953 Air Tube Rear *Not available as a replacement part. 37) 836-212 Baffle Insulation 38) 846-540 Insulation Weights 20 | Regency Wood Insert & Hearth Heate... -
Page 21: I3100 & H2100 Firebrick
81) * Brick Partial: 1-1/4" x 1-1/4" x 9" 84) * Brick Partial: 1-1/4" x 4-1/2" x 8" 85) * Brick Partial: 1-1/4" x 4-1/4" x 8" * Not available as a replacement part Regency Wood Insert & Hearth Heate... - Page 22 22 | Regency Wood Insert & Hearth Heate...
-
Page 23: Warranty
The authorized selling dealer is responsible for all in-fi eld service work carried out on your Regency product. FPI will not be liable for results or costs of workmanship from unauthorized service persons or dealers. - Page 24 Installer: ___________________________________________________________ Phone #: ___________________________________________________________ Date Installed: ______________________________________________________ Serial No.: __________________________________________________________ Regency and Classic are trademarks of FPI Fireplace Products International Ltd. © Copyright 2012, FPI Fireplace Products International Ltd. All rights reserved. 24 | Regency Wood Insert & Hearth Heate...
Need help?
Do you have a question about the H2100M and is the answer not in the manual?
Questions and answers