Table of Contents
Advertisement
Global Parameters
Parameter
Roam Trigger
Roam Delta
Roam Period
BG Channel Set
DFS Channels
Ad Hoc Channel
Aggressive Scan
Default
If signal strength is less than this trigger value, the client looks for a different
Access Point with a stronger signal.
-65 dBm
Options are: -50 dBm, -55, -60, -65, -70, -75, -80, -85, -90 dBm or Custom.
Available options may vary by SCU revision.
The amount by which a different Access Point signal strength must exceed
the current Access Point signal strength before roaming to the different
5 dBm
Access Point is attempted.
Options are: 5 dBm, 10, 15, 20, 25, 30, 35 dBm or Custom. Roam delta dBm
may vary by SCU revision.
The amount of time, after association or a roam scan with no roam, that the
radio collects Received Signal Strength Indication (RSSI) scan data before a
BG: 10 sec.
roaming decision is made.
A: 5 sec.
Options are: 5 sec, 10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60 seconds or
tom.
Defines the 2.4GHz channels to be scanned for an AP when the radio is con-
templating roaming. By specifying the channels to search, roaming time may
be reduced over scanning all channels.
Options are:
Full
Support for 5GHZ 802.11a channels where support for DFS is required.
Off
Options are: On, Off, Optimized.
Not supported (always off) in some releases.
Use this parameter when the
Specifies the channel to be used for an Ad Hoc connection to another client
device. If a channel is selected that is not supported by the by the radio, the
1
default value is used.
Options are:
When set to On and the current connection to an AP weakens, the radio
aggressively scans for available APs.
Aggressive scanning works with standard scanning (set through Roam
On
Trigger, Roam Delta and Roam Period). Aggressive scanning should be set
to On unless there is significant co-channel interference due to overlapping
APs on the same channel.
Options are: On, Off
Full (all channels)
1,6,11 (the most commonly used channels)
1,7,13 (for ETSI and TELEC radios only)
Custom.
Radio Mode
1 through 14 (the 2.4GHz channels)
36, 40, 44, 48 (the UNII-1 channels)
Function
profile parameter is set to Ad Hoc.
Cus-
5-15
Advertisement
Table of Contents
