Table of Contents
Advertisement
External Power Supply
In North America, this unit is intended for use with a UL Listed ITE power supply with output rated 12 – 80 VDC,
minimum 15 W. Outside North America, this unit is intended for use with an IEC certified ITE power supply with
output rated 12 – 80 VDC, minimum 15 W.
The external power supply may be connected to either a 120V, 60Hz supply or, outside North America, to a 230V, 50Hz
supply, using the appropriate detachable cordset. In all cases, connect the external AC supply to a properly grounded source of
supply provided with maximum 15 Amp overcurrent protection (10 Amp for 230V circuits).
An adapter cable is necessary to adapt the end of the DC output cable to the VX3Plus power connector.
Endcap Combinations
The VX3Plus endcap has two external ports in four combinations.
Caution: Do not use the RS-232 labeled endcap port for
cables with USB Plugs/Receptacles.
Serial / USB-C Endcap
One port is labeled RS-232. This is a 9 pin serial port and is designated as COM3. This port can be used to attach an external
scanner. The second port is labeled USB-C. This port provides a USB Client connection via an adapter cable.
Dual Serial Endcap
Both ports are labeled RS-232 and are 9 pin serial ports. One port is COM1, the other is COM3. These ports can be used to
attach an external scanner or an ActiveSync cable.
AC Power Supply
1. AC Input Cable (US Only)
2. DC Output Cable
Adapter Cable, AC Power Supply to VX3Plus
3. To DC Ouptut Cable (see above)
4. To VX3Plus
Caution: Do not use the USB labeled endcap ports
for serial tethered scanners or other serial devices.
2-19
Advertisement
Table of Contents
