Getting Start - Jensen JiSS-600i User Manual

remote will not work if the battery is installed with the wrong polarity.
CAUTION: Danger of explosion if the battery is replaced incorrectly. Replace only
with the same type battery.
3.) Insert the battery holder back into the battery slot.
NOTE: Only use a well-known brand of cell battery to ensure the longest life and
best performance.
Note: Before first use, please charge the satellite speakers for at least 12 hours
because the batteries may not fully charged, even though the LED lights.
You must follow the "Linking" process below to link the transmitter with satellite
speakers prior using this wireless music system.
1. Plug the USB Transmitter into the USB port of the docking base.
2. Press the POWER ON/STANDBY
hold it on the remote control to turn on Docking Base, the Power LED indicator
will change from red to green.
3. Turn the left satellite speaker power to ON and switch the speaker channel
setting to "Left", the speaker status LED will be flashing green.
4. Press and hold the Link button located on the back of the speaker box for about
3 seconds and then release it. The speaker status LED will rapidly flash green.
5. Now press the link button on the USB transmitter for 3 seconds, and then
release it. The LED on the Transmitter rapidly flashes red during the linking
process between the transmitter and the speaker.
6. When the speaker and transmitter successfully link, the LED on the speaker will
light solid green and the LED on the transmitter will slowly flash red. The
transmitter LED will light solid red when music is transmitting from the docking
base or from your computer.
7. Turn the right satellite speaker power to ON and switch the speaker channel
setting to "Right". Repeat above step 3 - 6 to link the right speaker with the
transmitter.
8. When both speakers are successfully linked, you will be able to hear the sound
coming from the speakers when playing music.
Note: If you activate the linking process during music playback, a beeping tone
will come out from the speaker for about 15 seconds after you press and
hold the link button of the speaker. A continue tone will be heard if you and
then press and hold the link button of the transmitter within this period.

GETTING START

button on the docking base or press and
9