Air conditioning units with kk2 control.
kl30 series;
kl30t series (11 pages)
Summary of Contents for KONVEKTA KL40T
Page 1
KONVEKTA KONVEKTA Air Conditioning Air Conditioning Air Conditioning Air Conditioning unit unit unit unit KL40T / KL45T KL40T / KL45T KL40T / KL45T KL40T / KL45T with control K5 with control K5 with control K5 with control K5 Versions: Versions:...
KONVEKTA spare parts or parts bought from KONVEKTA AG have been used for maint KONVEKTA spare parts or parts bought from KONVEKTA AG have been used for mainte- e- e- e- KONVEKTA spare parts or parts bought from KONVEKTA AG have been used for maint...
– antifreeze protection (conform the mixing ratio to manufacturers` instructions). This is abso- lutely necessary to prevent the heaters from frost damage! (The prevalent antifreeze filling of the vehicle manufacturers goes down to -40°C) : : : : KL40T KL40T KL40T KL40T...
If you think that the a/c unit is damaged, switch it off immediately. If you think that the a/c unit is damaged, switch it off immediately. To avoid further damage have it check at a KONVEKTA Service Station . Only after that you can take unit into operation. See hand book„KONVEKTA KONVEKTA KONVEKTA Service Stations“...
The cupper- and aluminium components of the KONVEKTA systems are not suitable for such extreme application conditions. We indicate emphatically, that corrosion is not subject to warran- ties for defects.
5.1. 5.1. 5.1. 5.1. Operati Operation panel / function of the keys Operati Operati on panel / function of the keys on panel / function of the keys on panel / function of the keys Note: Note: Note: Note: After the switching on the control is adjusted to the set value stored before it was switched off. 3 3 3 3 4 4 4 4 5 5 5 5 6 6 6 6 7 7 7 7...
5.2. 5.2. A/C operation ON / OFF A/C operation ON / OFF 5.2. 5.2. A/C operation ON / OFF A/C operation ON / OFF Start vehicle engine (refer to orig. operating instruction of the vehicle). Note: Note: If only the vehicle ignition was switched on without starting the vehicle Note: Note: engine, the blower speed will be reduced to the lowest level after 10 min.
5.2.1. Manual adjustment of the blower speed The set value will be indicated in the display. e.g. 21°C: e.g. speed 100%: The blower speed will be indicated by an illumi- nated display. Push shift-key „fan speed manual/automatic“: Press key LED „ manual adjustment“...
5.3.1. Manual heating operation => only in case of a/c units with heating option Press shift Press shift Press shift Press shift- - - - key heating operation: key heating operation: key heating operation: key heating operation: press key manual Adjustment“ is ligh is light t t t ing LED „...
5.5. 5.5. Switch Recirc. Air operation => only in case of a/c units with Rec. air flaps option Switch Recirc. Air operation => only in case of a/c units with Rec. air flaps option 5.5. 5.5. Switch Recirc. Air operation => only in case of a/c units with Rec. air flaps option Switch Recirc.
Also the prescribed regular maintenance works should be exe e e e cuted in an cuted in an cuted in an cuted in an authorized KONVEKTA service st authorized KONVEKTA service sta a a a tion tion ..authorized KONVEKTA service st authorized KONVEKTA service st tion...
Defect bearing on compressor. replace bearing or complete compressor only compressor slack V-belt check V-belt at compressor drive See hand book„KONVEKTA KONVEKTA KONVEKTA Service Stations KONVEKTA By user BAKL40T12AB Edition: 18.03.2009 Page: 14/15...
Warranty Conditions Warranty Conditions Warranty Conditions Warranty Conditions The current „General Warranty Conditions KONVEKTA AG“ will apply. A copy will be furnished by the warranty department. Please contact gwl@konvekta.com 8. 8. 8. 8. Waste disposal in accordance with legal provisions...
Need help?
Do you have a question about the KL40T and is the answer not in the manual?
Questions and answers