System Setup; Clock Setup; Time Adjustment Setting - Panasonic WJ-HD500A Operating Instructions Manual

SYSTEM SETUP

The described below let you determine the system desig-
nation and display the system logs.
1. Move the cursor to SYSTEM SETUP in the WJ-HD500
SETUP menu by pressing the C or D button, then
press the SET button.
The SYSTEM SETUP menu shown below appears on
the monitor screen.
9 SYSTEM SETUP
CLOCK JAN 1.00
TIME ADJUSTING
SET TIME
AUTO KEY LOCK
PASSWORD ALL
OPERATION
BUZZER
USER DEFINED SETUP
DISK MANAGEMENT
ERROR REPORT
SYSTEM INFORMATION
2. Select an item or item parameter in the menu by press-
ing the D or C button.
3. To return to the previous setup menu, press the
SETUP/ESC button.

Clock Setup

This item lets you set the current time and date.
1. Move the cursor to CLOCK in the SYSTEM SETUP
menu by pressing the C or D button, then press the
SET button to move the cursor to the right editing area.
2. Select the month by pressing the + or - button.
3. Move the cursor to the right by pressing the B button,
then select the date by pressing the + or - button.
4. Move the cursor to the right by pressing the B button,
then select the last 2 digits for the year by pressing the
+ or - button.
5. Move the cursor to the right by pressing the B button,
then select the hours (military time) by pressing the +
or - button.
6. Move the cursor to the right by pressing the B button,
then select the minutes by pressing the + or - button.
73
0:00
OFF
0:00
OFF
*****
*****
ON
*LOAD
7. After completing the setting, press the SETUP/ESC
button to move the cursor to CLOCK.
Note: The date and time are updated when the SETUP/
ESC button is pressed.

Time Adjustment Setting

This Disk Recorder has a time adjustment input/output at
the CONTROL port on the rear of the Disk Recorder.
This item lets you enable or disable time adjustment by the
input/output from the CONTROL port.
1. Move the cursor to the TIME ADJUSTING parameter in
the SYSTEM SETUP menu by pressing the C or D but-
ton.
2. Select the desired mode by pressing the + or - but-
ton.
OFF: Disables the time adjustment from the CONTROL
port.
MASTER: Enables the time adjustment output from the
CONTROL port to set the time for connected exter-
nal device.
SLAVE: Enables to set the time of this recorder by the
input from the CONTROL port.
The factory default setting is OFF.
3. If the parameter is set to something other than OFF,
move the cursor to SET TIME by pressing the C or D
button, then press the SET button.
The cursor moves to the right editing area.
4. Select the hour (military time) to execute the time
adjustment by pressing the + or - button.
5. Press the SETUP/ESC button to return the cursor to
SET TIME.