Table of Contents
Advertisement
3.3 System operation
3.3.1 User login
1. Start the system
Power ON/OFF:
Connect power cable to the DC12V port on the rear panel of this system. When the system is started,
it will execute a basic system inspection and run initial load sequence. After few minutes, the system will
load real time display diagram.
Password
Note: in default condition, password is disabled in system. When you enter any system menu, no
password is required. But, for the sake of safety, we strongly recommend you to use password menu to
enable and set the password of the system.
Note:
1）When the main frame is powered on, if no hard disk is installed on the device, or the installed
hard disk is not detected during starting up, or the installed hard disk hasn't been formatted on
the local device, then the following dialog box will be displayed on video preview picture after
starting up.
2）Newly installed hard disk can be used normally only after being formatted through local device.
New hard disk can be detected automatically during starting up and it will prompt you to format
hard disk; if it is required to format hard disk in the system, the procedure is as follow: main
menu>hard management>format hard disk or right key shortcut menu>system information>hard
disk management
2. System login
Open main menu:
Single click right key on any position of screen, and select main menu (mouse operation), or press
menu/exit button on remote control or front panel of system.
Note: if password is enabled in the system, you need to select your user name, and input 6-digit
numeric password, so as to open main menu.
User: user can select authorized user name in user check box.
Password: input the corresponding password of the user name.
Page 11 of 49
Advertisement
Table of Contents
