Table of Contents
Advertisement
• Mount the control cams on the profiles between the upper and lower tube of the railway
in the area of the platform stop position.
• Adjust the control cams - the levers for unclamping the barrier should be in the middle of
the
control
Note: Mount the control cams according to the description on the layout drawing. Under
some circumstances, it may be necessary to unclamp both barriers in the lower stop
position.
Caution:
• Check the power functions on automatic type platforms. Or check the operations on the
manual platform.
• Check each operation again for each landing in the system.
• Adjust the mechanical limit
block so that it is properly
aligned with the sensor on the
cover of the upper carriage.
Omega platform lift
OMEGA
Mounting the control cams
cams
when
Use
two
Do not mount two control cams in the upper stop position
(or intermediate stop positions)!
Mounting the ultimate limit switch
Adjust the ultimate limit
switch and the mechanical
limit block together!
Installation Manual
the
platform
arrives
control
cams
Edition Dec. 2004
in
the
stop
position.
in
this
situation.
page 20 of 24
Advertisement
Table of Contents
Need help?
Do you have a question about the Omega and is the answer not in the manual?