2.11 Password Setting
Follow these steps to change the password.
1. Choose the "Set Password" option from the "Initial Setup Screen" menu and press
<Enter>. The screen displays the following message:
2. Press <Enter>.
3. If the CMOS is good and this option has been used to change the default password, the
user is asked for the password stored in the CMOS. The screen displays the following
message:
4. Type the current password and press <Enter>.
5. After pressing <Enter> (ROM password) or the current password (user-defined), you
can change the password stored in the CMOS. The password must be no longer than
eight (8) characters.
Remember, to enable the password setting feature, you must first select either "Setup" or
"System" from the "Advanced BIOS Features" menu.
2.12 Save & Exit Setup
If you select this and press <Enter>, the values entered in the setup utilities will be recorded
in the CMOS memory of the chipset. The processor will check this every time you turn your
system on and compare this to what it finds as it checks the system. This record is required
for the sys- tem to operate.
2.13 Exit Without Saving
Selecting this option and pressing <Enter> lets you exit the setup program without
recording any new values or changing old ones.
Please Enter Your Password.
Please Confirm Your Password.
i945G2-IQNAR User's Manual 73
User's Manual