Intel i945G2-IQNAR User Manual page 41

11. Primary IDE connector (40-1 pin PRI_IDE)
These connectors are for Ultra DMA 133/100/66 signal cables. There are three interfaces
on each Ultra DMA 133/100/66 signal cable: blue, black, and gray.
Connect the blue interface into the motherboard's IDE connector, then select one of the
following modes to configure your hard disk drive(s).
Cable Select Mode - use this mode to select the operating mode by cable connectors.
No. of drives
1
2
Jumper Select Mode - use this mode to select the operating mode by hard disk drive
jumper.
No. of drives
1
2
Drive type
With OS
With OS
Without OS
Drive type
With OS
With OS
Without OS
Drive jumper
Cable select
Drive jumper
Master
Master
Slave
i945G2-IQNAR User's Manual 41
User's Manual
Cable connector
black
black
gray
Cable connector
black or gray