Intel i945G2-IQNAR User Manual page 65

User's Manual
Figure 2.18: Super IO Device
2.6.14 POWER ON Function
This feature allows you to wake up the system using any of the listed options. The
selections are "Hot KEY", "Mouse Left", "Mouse Right", "Any KEY" and "BUTTON ONLY".
2.6.15 Hot Key Power On
Awaken the system by pressing the hot key button. The choices are "Ctrl-F1", "Ctrl-F2",
"Ctrl-F3" to "Ctrl-F8".
2.6.16 Onboard FDC Controller
When enabled, this field allows you to connect your floppy disk drives to the onboard floppy
disk drive connector instead of a separate controller card. If you want to use a different
controller card to connect the floppy disk drives, set this field to Disabled.
2.6.17 Onboard Serial Port 1
The settings are "3F8/IRQ4", "2F8/IRQ3", "3E8/IRQ4", "2E8/IRQ3", and "Disabled" for the
on-board serial connector.
2.6.18 Onboard Serial Port 2
The settings are "3F8/IRQ4", "2F8/IRQ3", "3E8/IRQ4", "2E8/IRQ3", and "Disabled" for the
on-board serial connector.
2.6.19 Onboard Parallel Port
This field sets the address of the on-board parallel port connector. You can select
"378/IRQ7", "278/IRQ5", "3BC/IRQ7", or "Disabled". If you install an I/O card with a parallel
port, make sure there is no conflict in the address assignments. The single board computer
can support up to three parallel ports.
2.6.20 Parallel Port Mode
i945G2-IQNAR User's Manual 65