Jackson Avenger HT Installation/Operation & Technical Manual page 23

DELIMING OPERATIONS: In order to maintain the dish machine at its optimum performance level, it
will be required to remove lime and corrosion deposits on a frequent basis. A deliming solution should be
available from your detergent supplier. Read and follow all instructions on the label of the deliming solution.
NOTE: If this machine is equipped with a HTS-11, scale prevention and corrosion control device, and
lime is becoming a frequent problem, the cartridge needs to be replaced. To order a replacement cartridge,
call Jackson immediately to have one shipped to you.
To proceed with the deliming operation, fill the dish machine and add the correct amount of deliming
solution as recommended by the deliming solution manufacturer. The water capacity of the tank can be veri-
fied on the specification sheet (s) of this manual.
Perform the following operations to delime the dish machine:
1. Push Manual Switch on the front of the control panel.
2.Close the door (after adding the deliming solution).
3. Run the machine for the recommended period of time.
4. Press the Power Switch to turn the unit off and open the door.
5. Wait five minutes, then inspect the inside of the machine. If the machine is not delimed,
run another time cycle as per the deliming solution's instructions.
6. When clean, drain and re-fill the machine.
7. Run in MANUAL for 10 minutes to remove residual deliming solution.
8. Drain and re-fill the machine.
AVENGER Technical Manual (07610-003-34-01I)
OPERATION INSTRUCTIONS (CONTINUED)
Page Created: 03-28-2011
Revised: 03-11-2013
23