Twin Needle Sewing (Optional) - Kenmore 385.19110 Owner's Manual

Twin Needle Sewing (Optional)
Machine setting
_i_ Pattern
_2_LED display
_3_Foot
_4_Needle
A: Zigzag foot or
F: Satin stitch foot
Twin needle (optional item)
f
_i_ 01 10 11 13 15 16 1 7 22 23 24 25 26 33 34 36 46 47 48 49
CAUTION:
Turn off and unplug the machine before chan(
needle to the twin needle.
Use the additional spool pin and spoo
shown (refer to page 22).
NOTES:
Twin needle is an optional item.
Use size #60 or finer
Make a test
Threading from _i_ same as the single
needle (see page 28).
Slide one of the threads through the needle bar
thread guide _5_ on the left and the other one on the right.
Thread the needles _6_ from front to back.
Turn the power switch on, and select the stitch
pattern. Reduce the stitch width to 3.0 or less.
I CAUTION:
Do not set the stitch width wider than 3.0, otherwise
the needle will hit the needle plate and break.
Sew at a medium speed.
At corners, raise the needles until they clear the
fabric.
Partially raise the presser foot and carefully turn the
fabric.
When twin needle sewing is completed, change
needle and reset tension if necessary.
NOTES:
The needle threader cannot be used with twin
needles.
To avoid the thread twisting, it is advisable to
thread the machine one thread at a time.
. J